Yes, but can an undertaking such as this be done in a piece-work manner ? And where do you start ? The underlying support deep in the bilge ?...
Where you been F14 ? The removal of decayed structure for replacement can take months(recall spending an entire fall season removing bronze...
The APA1-95 specification was revised to voluntary standard ps1-07 and later to ps1-09(in 2010). Otherwise, the panel listed above in the...
It's all good. It was this stuff. APA spec. Ps1-07, rev. Ps1-09. www.harborsales.net/tabid/130/Default.aspx?ProductTypeId=135 and using...
The long name is Medium Density Overlay. MDO. The type used for outdoor signage. There may be an interior version although I haven't come across...
Ok to put on some tunes first? [www.youtube.com/watch?v=ft82a4qZZ9E] MDO plywood is my new favorite. A couple of sheets were used to...
If my life depended on it I'd propose the hull had a foot or two of water in it and froze. Then envision a foot of wet snow over a couple of...
That spot in the picture of the keel at the forward blocking : looks as though the garboard plank has a hole and the keel at this location also...
Two more oil changes. And these relics take about 8.5qts each. After seeing how you turned that wreck of an OMC/Bayliner into a work of art,...
I'll start measuring, and thanks much.
Yes. The engine-room-mounted raw water intake strainers. Is there a recommended intake/outlet size or a chart with recommendations. The units...
I am looking for recommendations on the seawater intake strainer inlet/outlet size that should be used for my application. 1969 Chevy 327 engine,...
They seem to have wandered off ! Hmmm.
:idea: Greetings Mikovio, Hows it going? The decks on my project were covered with resin soaked canvas. More resin was applied at a...