Thanks for reply , i made several times the multistep infusion with vynilester but never with epoxy that is very choosy for the joint for...
Hi Guys , i have to build a 10 m boat (fibercarbon sandwich ) using infusion method. I would like to know if is possible to perform in 2 step ....
Hi Guys , I have a small pushboat with a Displacement full load 350 Kg so my question is there the possibility to push a barge with a similar...
Thanks for the precious support so we can keep the scantling of post 19 ( that is perfect regarding CG calculation and freeboard ) and the...
Sorry for delay.. http://imgur.com/a/yXxPw http://imgur.com/a/9JUow http://imgur.com/a/C1SHL 8800 mm. Loa 2900 mm. Beam 2x250 Hp Outboards XL...
An Out of argument question what do you think about the thickness of 5 mm for the bottom and 3-5 mm for deck ? It is accordant with ISO 12215-5...
I hope that was misunderstanding....thank you so much for your precious support and clarification.
Hi Guys , what about the weight of welds for a 8.8 meters aluminium center console using MIG ?How can it be estimate ? The aluminium is 5083 . I...
Hi Guys , what documents and certifications needs a boat that will be imported to Australia ? The boat is 8.8 meters .There are also restrictions...
Thank you Barry for you clarification and precious support. Regarding an aluminium planing hull like the following pic...
Hi Guys , i have seen several system to protect the Aluminium Hull in the last years like the use of magnesium , zinc anodes or only coated but...