Use that sprayer I was talking about. Take some time spraying it. Wait a little bit between coats. And the sanding through sounds like to thin...
Have you tried using acetone to thin the gel. You can pick up a small cheap self contained spray can at Home Depot for $3.00 or so. Get rid of...
Just thought I should add a shot of a Redfish. One of the many from last summer. And a first for Mike.(guy holding red)
This a boat I rigged for a buddy of mine. Lowrance combo unit, cdplayer with speakers in the front storage boxes, VHF, lights in console,...
She is a 1968 20 Dusky cc. I am currently in the process of rebuilding. She was in rough shape. All the wood in her was bad. The cap is on a...
Almost forgot. Good Luck!
Cold here today. Down in the 50's, and the wind is blowing a steady 20 from the north. No fishing for me today.
I would check the max RPM's of the motor. Should be around 4500RPM at WOT. That could be part of your problem.
Hey Fisher, What is that white stuff? Haven't seen that down here!!!!
Do you have any wood damage? And do you own a grinder. If no wood damage you could just grind out the delam area. Sand the area that you will...
If you have rear storage compartments you could use the Yamaha Rigging Tube Kit. Cut a hole put the fitting in and run your wire through the...
Oyster, thanks for the help! You sure have a good working knowledge of this. You must have spent a lot of time in a boatyard. Thanks again. I...
Wonder who was the lucky one that got that. lol
Oyster, thanks for the advise. The wood is in rotten shape. But it still has been very slow going on removing glass and lumber. I will sure try...
Antonio I am very interested in using urethane foam. I am currently rebuilding a 20 Dusky center console fishing boat. And if there is a way to...