I have the pod but when I get into it after the engine drive removal I will decide on the pod or cutting out a hole to mount the outboard on the...
I’d have a kicker its a 9.9 Yamaha 4 stroke for the trolling pod has a mount for it to.
I have an outboard engine pod. And a 125hp mercury outboard probably a little small for this Slickcraft boat considering it’s pushing around this...
When I have to make the inevitable repairs, I’d rather be looking for Mercruiser or Volvo parts. And the right donor boat it would be financially...
I have a 75 Slickcraft 22' I inherited. Beautiful hull. Has a complete 225 OMC setup in it, only 597 hours on engine runs great. I'd like to...
I've rebuilt transoms before using polyester resin and mat and never had a problem. And will have at least two knee braces between the two outside...
Was thinking glue to prefab it but I could do the same thing with my polyester resin and cloth .
Pretty much made up my mind to use 3/4” 1/2” 3/4” glued with titebond111 glue .
Rebuilding the floor and transom on this bellboy. Ready to install transom but wondering if the previous 1.5” thick transom and two sheets of mat...
Everything is glassed. And I have done the pvc pipe thing through the stringers before, looks like I will be again.
I converted my inboard boat to a outboard transom complete with a splashwell, that leaves me five compartments lengthwise below the floor. They...
Been busy on other things. Got it painted, floor all done front seats in, finishing off fuel tank covers/back seats.