That is where I intend to buy our fiberglass supplies from. I'll ask for Ted Wilson. Thanks.
Here's a link to the referenced video. He was actually using Vinylester laminating resin. Per a comment I made, his response was that the epoxy...
Thanks for all of your responses. I just watched a YouTube video by "Tiny Boat Nation" on replacing the transom core. His method resolves the...
My son bought a 16 foot fiberglass boat a few years ago. Don't know the brand or model. The transom core was soft so he is currently replacing...
Good to know what the norm is for handling the gas in the fuel line. I've been buying non-ethanol gas and add STA-BIL for all of my gas...
Yes, the gas tank is separate from the outboard. So do folks push the the two check valves in, (I assume there's one on both ends of the fuel...
Have a new outboard motor. When the fuel line from the gas tank to the outboard is disconnected, there's left over gas in it. Does everyone just...
Very good point that I had not considered. I'll check that aspect out and decide. My boat will only be in the water while we're using it. Thanks!
Sounds good. I'll go with 15 degrees for the transom for the boat I will be building. Thanks.
Thanks for your input.
One setting for my Tohatsu 6 HP outboard puts the transom angle at 15 degrees. I'm thinking building a boat with a 15 degree transom angle would...
The highlighted sentence in your response is the whole reason for my starting this thread. I don't see how the pressure between a fixed member...
