almost 12 months ago
Chrysler were in the marine business they were all factory chrysler in Australia same with everywhere else.
One came to Singapore for a 23' charter fishing boat. Dealer bought it back said another one will be the same, so sorry Dealer was pretty much at...
Sure it will pump, think of a 25" engine pumping from a vee hulls tank in the floor.
The viable busines that went broke as they couldnt get a boat out the door for a profit let alone even tell you when you would get it. Yes lots...
There are lots of starter and alternaters designed like this. Very common on Euro engines for decades, same for the engine sensors. Requested for...
The bonus was Farrier made the beams for you so I dont think there was ever any plans for them? The whole Farrier setup was for home build....
Once you have used rubberised epoxy like spabond you will never go back to making glue
its creates less drag, common on many large outboards when the case is a little bigger but uses existing range of props
did you try just routing the tell tale hose into the boat assuming its warm, what model was it again? Can always add a tell tale if its not from...
There was a OMC 9.9/15 sail version that had a vented extension so you got the thrust back in reverse, they had plenty in fwd so not an issue....
Hows the primer bulb when you let it sit, primes like from first startup or its full of fuel? Where is the tank in the boat height wise compared...
BRP cocked up with selling them saying buy one as they are 2 strokes when the Japs had already done a massive lobby to convince everyone 4 strokes...
The thermostats are after the block. Typically for a 2 stroke, thermostats are on the heads and they dump down the heads and out into the...
What comes out of there is the water that overflows the water from the inner exhaust housing, its fills to keep it cool and dampen sound, its not...
