I think I will go with 4" angle iron laid directly on the stringers and side bolted throughthe stringers with 1/2" bolts and backing plates made of 1/2" kevlar.
I will post pics in the next couple of weeks when install is complete. Thanks for your replys.
Mark
I have recently removed all old stringers and installed new foam stringers with a 1/2" of fiberglass over them. I have considered using 1/2" Lag bolts but is 1/2" thick fiberglass enough to hold down the 1400lb diesel engine? I have enough height out of stringer to cut 4" holes with a hole saw...
If I were to trim the keel a bit....I could live with taking away low speed tracking if it would help the the chine walking. I'm not sure that taking away keel depth would create any issues aside from this do you? The boat is pretty flat in the back so stability at idle wouldn't be a concern...
I have a 26´ 6" custom built boat that had a 210 hp cummins and has been repowered with a 330hp bta. The cruise was 17-18 knots and now has a cruise of 22-23 knots. The hull is very similar to a shamrock with a 8´6" beam. The only difference is the keel is 18" at it´s deepest point from hull aft...
My Email is marktillman32@gmail.com If you will shoot me an email I can send more pics and info. My boat is back in the water, however, if you go to the link below there are some pics of it on a lift and I do have plenty more on the hard...
Phil,
I am looking at putting some lifelines and bow pulpit on mine. How far are your stanchions apart? I pulled my other tank yesterday and the same problem with the nails puncturing the bottom of it also.
My engine hatch and deck hatches are 3" above the deck and I am considering...
I watched that boat for a while and decided it was to far from me. I'm in Pensacola, FL. I ran across my clipper in Merritt Island, FL Originally mine was shipped form the west coast to the north east and then it motored down to the keys where the owner I purchased it from picked it up. My...
I am doing the same....What do you know about the builder? I think mine was built for a pleasure trawler... it has a lot of teak much of which has been glassed over. I attached some pics.
Mark
84 monterey clipper fiberglass
Here is a 1984 Fiberglass Monterey Clipper built by Joe Fellipi of Moss Landing CA. Boat is undergoing paint. Located in Pensacola, FL
Does anyone know of this builder out of Moss Landing, CA? I just purchased a Monterey Clipper built by this designer/builder in 1984. Any info would be great.
thanks
Mark
I understand what you guys are saying now that you have brought this to my attention. This was a concern because of the freeboard as it sits. I would love to find a 33' navy utility hull made by willard. What are your thoughts on this hull if I could find one.
Mark
I am wanting to build a small version of the biloxi lugger.......I would like to build the top side of this lugger design on the hull pictured below. The hull is 30' x 9.5" has a max freeboard of 47" in the bow area to waterline and 27" freeboard at the minimum to waterline. I would add...