you will have to try! All of these propeller "guesses" are jus for an approximate measure. What really works is to take some 3 or 4 props, load...
I made it!! I have a 351W that was recently overhauled. it has iron heads, with large intakes, and also low profile stainless steel valves,...
I think marine engines does not have O2 sensors... tke a look at this thread: http://boatdesign.net/forums/showthread.php?t=2063&highlight=efi
overheating Have the #7 checked. Remove the spark plug and check it for moisture, then crank the engine ( unplug the coil , so it won´t start)...
overheating Where did the water you´ve found on #7 cylinder came from? There are some likely sources of water on a cylinder: a cracked exhaust...
351W overheating I have a mercruiser 351W engine, and i´ve been through that a while ago, perhaps i could help. You must have water flow to cool...
i have a ford 351 block i have a ford 351 block, bijet carb, on a 20 feet V-hull boat, with an OMC cobra outdrive. with a total displacement...
I have a 20 footer V boat, with a mercury / Ford 351W engine, recently overhauled, and runs flawlessly. The drive is an OMC Cobra. It has a...
I know that hot salt water is extremely corrosive and would easily corrode engine parts like risers. And also the engine compartment must not be...
Thanks Brainsboy and Jango!!! Actually i have already purchased my pistons, they are keith Black hipereuthetic , -19cc dish, with iron heads,...
I´ve been through that!!! I faced the same situation 6 months ago. My Ford 5.8 had water in the oil but was running fine for some time, just a...
Hello folks! I Have a 20 feet boat with a Mercury ford 351W engine. It had a water leakage problem with exhaust manifold witch spilled water on...