This forum is taking a turn I was not expecting. I thank those who contributed constructively for their time and insights, and will proceed from...
Ad Hoc, thank you for your very informative and ad hoc remark. Very much appreciated.
Guys, thanks for all the input. However, and apologies if this may come across as blunt, ... ... what I am asking for is technical support. Not...
Some owners take to sea without finishing. Over time it seems all marks also disappear. But since I have a few months ahead of me while they are...
Hi all. A few photo's of other boats from the yard. This is the standard level of finish leaving the yard. The picture of the boat in the water,...
Just for the record to all. I am confident about the builder (experienced aluminium builders in Holland), and have no doubts about the quality of...
Thank you for the tip on the Pferd Polyfin grinding wheel. I found the references, and will try this out after the weekend. I will also post some...
Thank you all for the feedback. I am currently trying to get the procedure right on a testing zone. This is the top of the hard dodger, which will...
Hello Barry (and others for fast response). The hull was professionally blasted and epoxied below the waterline. And no, the hull above the...
Hello. I am looking for tips and information on proper equipment to finish an aluminum hull. At this stage the hull has clear scratches/swirl...