to get them for the full boat plus maybe 12 foot extra €40 euro so around $50 dollars. (coming direct from joiners rather than hardware supplier)...
yes i have dried her and been running dehumidifier last few days , new teak stringers getting cut in joiners will have for Saturday so that is 3...
thanks Blueknarr yes i had seen previous threads here and elsewhere mentioning this Method, I agree this is the best solution. the main...
yes i just wanted to keep as much as possible before proceeding. i am wonder if i can do one of 2 ways 1) leave 1/2 the tabbing in height, add...
Only got to start this eve and cut out the top section , the stringer on the left had water in the fiberglass casing when I removed it. I’m...
no Problem The Q , i have one drill hole through hull at present and the fibreglass is solid and not layering , so holes are already above water...
i have an engine and a mechanic that will sort for me , but i am thinking of getting a 2nd hand perkins engine cost around 3000 -4000 dollars...
Thanks James , the cap is on for sure I have been working inside in the dry. No I was offered to buy the mold but I did not take it’s still...
Cap on as far as I know
Hi Sam I have worked in restoration projects most of my life until about 8 years ago . We mostly done old Georgian houses and deceocotuve work...
yes on thinking now i will fill this hole , as we only drilled it to drain the water out to move the boat to my house. as the boat was 1/3 full of...
perfect thanks James
yes these are not limber holes , so just fill with resin and glass over them ?
thanks re the holes called Limbers i am learning all the time re the hole in boat : is it not a good idea to have bung to allow water to drain...
the holes look like drilled or just appeared very small 5-6 ml , the transverse is solid as such