Recent Content by paintbylumbers

  1. paintbylumbers
    Post

    Boring a hole for a pipe

    I am cutting up a PE cutting board to make skid plates out of so there is no rubbing inside the centerboard trunk. They are going to be planed...
    Post by: paintbylumbers, Apr 28, 2013 in forum: Boatbuilding
  2. paintbylumbers
    Post

    Boring a hole for a pipe

    Thanks again!
    Post by: paintbylumbers, Apr 27, 2013 in forum: Boatbuilding
  3. paintbylumbers
    Post

    Boring a hole for a pipe

    Thanks Thanks everyone! Any ideas on keeping it perfectly square? Possibly clamping it down to one side of the hole? Thanks again!
    Post by: paintbylumbers, Apr 27, 2013 in forum: Boatbuilding
  4. paintbylumbers
    Thread

    Boring a hole for a pipe

    I am looking for some tips on making a hole for a 1in pipe. I am using the pipe as the pivot point for my centerboard. I have a 1-3/8 bit but it...
    Thread by: paintbylumbers, Apr 27, 2013, 9 replies, in forum: Boatbuilding