Next >The aft 33% of the bottom needs to be straight buttock lines and squaring off the rounded chine aft would be helpful too.
Around 1999 I made a 12.5' model to test at the Stevens tank. It was a 1/10th size motor yacht hull. The model was tested with round bilges then...
Yes they are available. My present building is packed. No room for production boat building. I have a fellow in Florida looking for a builder to...
Bump. These molds should find a home. The build books detailing the construction is a graduate course in composite construction alone. The Cat...
The Phone number where you may discuss the molds and production. (252) 628-8065
Was $35,000 Price reduced to $30,000
The Molds are Still Available
The information you require is posted in the thread.
I am surprised too. We got a quote to have a plug and mold fabricated for our recent catamaran design. Its $200 / sq / ft. That makes just the...
I had not considered this before an inquiry suggested it. With some work it may be possible to fit the molds into a container, especially...
I build a 70 mph Center Console Catamaran and I hate fastenings too. There are six for each engine, and a few for hinges and hardware. Our T top...
I really like this boat. The designer Pete Melvin really likes this boat. He has one for his own family. You will really like this boat as does...
So Aerodynamics for dummies. Disregarding a drag reduction from lift, If my 39' center console catamaran goes 75 mph with (2) x 350 hp, how much...
I am getting several inquiries a month regarding the 22 cats. This would be a good start for someone to jump into the buisness.
Bump.