So, back to my learning double ender Pirogue. Having got the hull draw techniques sorted, I want to add a 2' deck at either end (I am working on...
OK. I hope this helps somebody else confused by this. The peculiar picture I posted was of _all_ the plates, still joined. I had hoped that...
I did read the manual. From my OP "The Help seems to indicate that even if I have different parts of a boat in the same layer (like, I assume...
This is what I am seeing.
OK. I tried _again_. This time I asked for 4 vertical control points. I then creased all edges to produce a double chined hull. All on a single...
OK. I tried again. As "without human input" as possible. I started a new design. I asked to have 3 vertical points and everything else...
Thanks for the reply. A GOOD thought! ...But no....;) I have marked the only layer in the design as developable. This is a very simple hull and...
Note: I have posted my findings, after much surfing, in a lower post, in the hope that somebody may be helped. I have designed a rough and ready...
I reckon you are going a bit far in defence of the insurance cos. I agree they should make a profit, but they have lost sight a long time ago of...
Thanks for that. It seems wrong that all tris should be tarred with the same brush......
I sounded off without answering...but it's still about fear.... OK For me in this words, I want 3rd party coverage. These days you can be up...
Interesting. In an age that is increasingly litigious and combative, we have insurance companies turning away income because they fear the...
Well I guess we need to know what "golden oldies" are....