So, "eyebrow" is the common name for this thing? Yes, there are a lot of information if you want the explanation for a specific word, but not so...
Agrees with the previous post. This excellent forum should be available on tapatalk or similar. Is that project closed?
Hello! What's the designation for this type of screen? And by the way, is there some site with a glossary of "boat part" terms? [ATTACH]
Hello! I have a question about the offset-load test. The situation is this... An open boat with a selfbailing deck. Is it allowed to have...
It's hard to see clearly in your picture, but i think you have to make an edge between the new points. Quote from the Freeship manual. 1.2...
Tangoau, good luck with your project. This is what happens when your beam gets a little wider then expected. Door post has to go out. ;)...
The red colouring at the forward end of the bottom plates is caused by a three-sided surface, i think. Freeship/delftship doesn't "like" such...
Hi. Yes, they are similar. I searched this forum for help to interprit the Freeship stress values, but found nothing. Delftship has the colour...
Hello! Maybe this one? http://www.boatdesigns.com/Carolina-Angler/products/729/
It worked! This is the same hull developed in Delftship this time. The files was prepared in Draftsight, and sent to a watercutting facility. I...
Here is a picture from Delftship. I did some fiddling with the controlpoints, and now i se that the vertical lines between points on sheer and...
Correct me if i'm wrong... The vertical edges between faces, along a developable hull side, or transversal edges along the bottom are in fact...
