Rebuilding a hull, from the ground up. I've layed about 3-4 gallons of epoxy so far. Never used a respirator when laying glass. Only use the dust...
Just curious, what types of masks/filters do you use when laying epoxy/sanding.. Currently I don't use a respirator when laminating, although...
Comparable to coosa 26 lb density board
Penske
Yes, I figured trim tabs is a must ...
Well my plan is to float it after the stringers are all in, and a bracket is mounted. I can simulate weight with drums full of water - this well...
For the transom I will be using three 1/2" pieces of composite board, with a layer of 1708 between them. I will probably do 3 layers of 1708 on...
Yes, the transom will be reinforced - multiple layers of penske board and lots of glass :) Weird , that link should work - I'm not sure why...
Mr Effiecieny, thanks for the response - i guess all of the above is what could be of concern. I do think it will pick up some top end, and...
Hey folks - I rarely post on this site, but I do browse from time to time. I need some serious advice on my project. I'm leaning towards...
well, i have some older photos.. i can take more detailed tomorrow. Heres a few of the hull, i have a few old ones on this computer when i was...
Thanks for the feedback. Can you elaborate on torsional loading issues?
I'm currently restoring a 1978 26' pacemaker that I picked up a little less than a year ago. Basically got the hull for free and it came with a...