Recent Content by Mylestec

  1. Mylestec
    Post

    LED Light voltage limiter

    Simple two wire plan.... West marine 4 place fuse/switch panel, three buses: one common negative, one running light, one cabin light - to which...
    Post by: Mylestec, Mar 26, 2009 in forum: OnBoard Electronics & Controls
  2. Mylestec
    Post

    AC/DC Grounding W/out Engine or Plate

    Thanks for your help David... I need the charger for higher amp charging needs to replenish the bank between uses (not just a trickle charger)......
    Post by: Mylestec, Mar 26, 2009 in forum: Electrical Systems
  3. Mylestec
    Post

    12V LCD Monitor Power Supply??

    Try this... a USB powered 4.3" monitor.. http://www.crunchgear.com/2008/10/13/tiny-43-inch-usb-powered-lcd-monitor/
    Post by: Mylestec, Mar 24, 2009 in forum: OnBoard Electronics & Controls
  4. Mylestec
    Post

    AC/DC Grounding W/out Engine or Plate

    CDK; Let me make sure I understand you: Assuming there is no ground to water, then AC/DC systems, bonded together through the Shore AC ground...
    Post by: Mylestec, Mar 24, 2009 in forum: Electrical Systems
  5. Mylestec
    Thread

    AC/DC Grounding W/out Engine or Plate

    While there appear to be at least a few threads regarding the general grounding topic I haven't found one that deals with my specific situation....
    Thread by: Mylestec, Mar 24, 2009, 5 replies, in forum: Electrical Systems
  6. Mylestec
    Post

    LED Light voltage limiter

    I see there are differing opinions regarding my LEDs..... I'd love to go with PistnBroke's solution of slapping them in place without any...
    Post by: Mylestec, Mar 24, 2009 in forum: OnBoard Electronics & Controls
  7. Mylestec
    Post

    LED Light voltage limiter

    @ Pistnbroke & Kroberts: I thought the same thing until a technical question to the vendor yielded a response that stated these types of lights...
    Post by: Mylestec, Mar 23, 2009 in forum: OnBoard Electronics & Controls
  8. Mylestec
    Post

    LED Light voltage limiter

    Thanks again Matt.... in that case it may be best to make one epoxy encased regulator that can handle the entire load and feed it to a 12v...
    Post by: Mylestec, Mar 23, 2009 in forum: OnBoard Electronics & Controls
  9. Mylestec
    Post

    LED Light voltage limiter

    Thanks Matt! Is this something like a Zener diode? Any suggestions on how to integrate it into my lights.... for example, would I solder it in...
    Post by: Mylestec, Mar 23, 2009 in forum: OnBoard Electronics & Controls
  10. Mylestec
    Thread

    LED Light voltage limiter

    Greetings to all; Please pardon me if I've missed this topic posted elsewhere but a quick search only found remote and tangential topics....
    Thread by: Mylestec, Mar 23, 2009, 17 replies, in forum: OnBoard Electronics & Controls