Since I have now cut parts it is a build.
Thanks for the input. I've decided to stick with ply and go with my original plan which is a plank on frame skiff.
So I have seen Nidacore and Plascore honeycomb panels made into designs for plywood. At this point I’ve built eight wood boats including a...
While I have not worked out every detail yet the project has begun: It started with realizing that I have built enough flat bottom boats to know...
Bit more freeboard, aft rocker
That is an interesting design. It’s not exactly what I’m looking for though.
I have no doubt I could work that in plywood without issue. It might sit a little high on its lines. Total hull length must be less than 18 ft
[ATTACH] I have not posted in some time however I enjoy reading the site. Over the past three months I built a seal cove skiff in plywood. It is...
Thank you for the response that is constructive. I would happily build that if I could shell out for a new 35 hp 4 stroke. It looks like a good boat
Here is the main diagram:[ATTACH]
Despite having spent a very large amount of time on small boats and having built, and designed then built a few, my posts may have revealed a...