Success! I was having so much fun I forgot to take a picture until we got the boat back on the trailer. It is fast. The weight balancing is...
I got everything loaded up and drove down to the dock Friday and they had removed the dock for the winter. I'm not sure I'll be able to launch...
Is it advisable to put a float on the top of the mast to keep it from going upside down if it rolls over?
Yes, they are bolts, with a nut under the rub rail. They looks small, but I guess the line is attached on both sides. No, I don't have any of...
My boom has three pulleys attached to it. Two in the middle and one at the end. The Barney post has two pulleys, a double block I think it's...
I'm puzzled a bit by the rigging. Any pictures you can share?
I think this was the stuff: 3M™ Marine Adhesive Sealant 5200 | 3M United States...
I made some good progress on the rudder, I'll send pictures when the epoxy dries. I think it really looks nice. I used that 3M marine sealant...
Good stuff. That bulkhead is a work of art and those boxes under the seat look solid. I'm thinking I should take it out on a light wind day and...
Any suggestions where to get an inexpensive jib sail? The boat didn't come with one. I was playing with the idea of trying to sew one up myself,...
I think I'm about done with the mast support. I ran a cedar board from the centerboard slot up into the bow. On top of that I ran two parallel...
I've got to give them credit, if it had bonded better at the bottom the foam roll under epoxy would have been pretty solid, as it is though the...
I made a rudder out of home depot oak. It's the wrong kind of oak I was reading though (red oak), so I coated it with a thin layer of fiberglass...