Unless they are worlds shortest stringers………I’m guessing a boat of that age is 3/4” plywood on edge and then a small plywood box on the inboard...
Except the mounts between a 4.3 and a 5.0/5.7 are in different places……the V8 is also a couple of inches longer
Really two things Did it steer poorly before…if yes then adding area can help But adding the area will increase the loads on those reused...
H boat - basically a soling with a cabin
I am very confused as to why you would build any boat out of HDPE……it recyclable…..OK…..but it’s heavy and not stiff…not exactly a great...
Ok, in the recycling it goes
What’s the maximum thickness that the mounting for the outboards will take……I’d use that and then figure out how to tie the transom into the rest...
All I have a 3” binder full of older papers on fiberglass design (nothing hi tech, all good old polyester and glass). Includes: Owen’s Corning -...
All Looking for ideas, I have my set of yacht curves from college (late 80’s Southampton Institute) and finally have a home office with space to...
Read up on prismatic coefficient…..way too low as a starting point Where will the LCG be?
Begs the question why….. And 6.3 is probably a bit high……but again why?
And laminating a near vertical topsides towards the laminator will have no impact on quality…….look at your website, a small mold that rotates! I...
There’s more to it than that, how easy is to reach the centerline….a rotating mold makes that much easier……what’s the laminate schedule - than can...
