I don't believe that is a oil pressure port. Most 350 chevy's have a sender by the distributor 1/8 inch pipe thread and also one at the front...
There is not a lot of differences between rt hand and left hand .GM motors as opposed to Fords. GM does not have an offset to their pistons for...
It is great to see this Thread be started again. It gives me ideas of where to visit when traveling. The houses could they be Stiltsville...
Par is correct about timing. He said before top dead center, you said after top dead center which is important. Setting it 8 after top dead center...
Great Hoyt-- Your turn. I thought he would make the Darwin list:) I told you it was easy. My next hint would be Hippo.
Hoyt, you have the Country but the wrong State, A boat did go over the Falls:D
I have not seen someone put another " where is this" in the last few days. I was close in that I had the Cenotes and the area but did not give...
Are they the Cenotes of Yucatan ?
Check the compression again with a good tester, if it is still low that means something around that cylinder. The backfire through the carb might...
I had a problem similar but it was with temp difference between two motors. Did all the things possible senders, gauges, cleanout heatexchangers...
I have a little problem with the time you say 3 men will be able to build 3 boats. You first say that 3 men building 3 boats will take 3 years....
It is one of those old wifes tales to soak them in oil. They are easier to adjust if dry. Install with assembly lube to keep the lifters from...
It is a merc block, designed by them. It was thought that they could design an engine better for their needs, a very large four cylinder. Larger...
When I look at Maagen it reminded me of another boat. Question - Does anyone know if Richard (aka Apex I - no longer on the forum) ever built...
It looks like a 302, if you look at the picture of the back of the block , the block is the same height as the bell-housing. On a 351w the stroke...
