I'm afraid that my spray rail design would have very little effect in correcting a static buoyancy issue such as you described. MM
Thank you, That was a wonderful article that I read with great interest. Mike
farjoe, The 123DCatch.msi I have is 91,488KB in size and like most of the photogrammetric software out there uses cloud based computing to...
123D Catch Hi farjoe, There's no way for me to tell why 123D Catch doesn't open on your computer. The hardware requirements are fairly...
Importing a 3d Model into DelftShip For as long as I've been using Delftship it has always been my hope that one day I would be able to import...
There's some good advice here namely using lower speeds, lighter pressure, and a vacumn attachment to quickly remove the grinding dust before it...
Personally, I don't see any significant problems stretching this hull, at least no more then one might normally encounter during such a procedure....
Mold release treaments will vary from person to person, but my favorite continues to be Johnsons Floor Wax applied over three or four days time...
I recently finished construction of a 13'6" hull that utilized no stitches whatsoever thereby eliminating all of the holes and stitches normally...
Agreed Par, the owner has a number of ways to address these issues and more then enough advice to help him decide on a course of action MM
Gentlemen, One thing I think we can all agree on at this point is that Discoverys' main concern should be the refit of an improved skeg. But I...
In my mind it's always been about two forces contending with one another...the current flowing by the underwater portions of the hull and the wind...
Agreed, it is often best to stay with the material you're most accustomed to using. In the case of the spray rails however the benefits of a...
I have been a persistent advocate of spray rails and will remain so as long as my personal experience continues to validate the benefits derived...