Ondarvr, thank you for the reply and knowledge. I see the reasoning for your replies. All in all, providing this other stringer cures a little...
10/4. I’m using 20 Ml/Cc & 6Ml/Cc syringes for micro batches. 30 Ml being right at an ounce. I did sand the 2nd. Good stringer earlier today and...
And another thing. I had this polyester that had been just sitting around and was kind of thinking it’s going to go bad before I ever open it....
Thank you ondarvr. I started out with epoxy and cloth, It rolled and buckled up on the radius and got several air pockets. The wood was already...
Hello all. I’m going to admit guilt right out of the gate. I am an epoxy guy and just started dabbling with polyester and csm the other day. As...
I appreciate the feedback. Thanks again as always.
Ok thanks. originally from factory this one is about 18" as I had said. If I raised the floor in my build back It could end up at 15"-16" Some...
I don't have any pic's or drawings. The simplified question is. Is there a minimum desired or safe height from the floor or deck to the top of the...
This question is a little odd. But I have good reason. I will be adding scuppers in my build. There was a single drop pit or small pan to describe...
I may worrying about nothing... All the wet foam I have encountered has been in 40-50 yr old boats. After going to all the rebuild efforts, I...
I can envision a Bean Volcano. Lol.
I don't figure thats a formula I can get easily.
Ok, thanks to all the replies I have been thinking on different ways to keep moisture away from stringers and still use pour foam. So heres the...