Recent Content by lyqqmxm

  1. lyqqmxm
    Post

    Double bias function in sandwich panel

    Thanks for your answer. In ISO 12215-5 or other rule, the requirements for single-skin plating and sandwich plating are checked in the two...
    Post by: lyqqmxm, Mar 18, 2014 in forum: Boat Design
  2. lyqqmxm
    Thread

    Double bias function in sandwich panel

    hi all i have a question, why the double bias is sometimes recommended for use in sandwich panels. in my point, it exhibit low values for σ and...
    Thread by: lyqqmxm, Mar 16, 2014, 6 replies, in forum: Boat Design
  3. lyqqmxm
    Post

    Structural bulkhead in ISO

    A good idear Thank you verry much
    Post by: lyqqmxm, Sep 24, 2012 in forum: Boat Design
  4. lyqqmxm
    Post

    Structural bulkhead in ISO

    Thank you for your help, which rule should be referenced for pillar in ISO , 12215-9?
    Post by: lyqqmxm, Sep 23, 2012 in forum: Boat Design
  5. lyqqmxm
    Post

    Structural bulkhead in ISO

    WT bulkheads and structural bulkheads Hi all I have some doubts about WT bulkheads and structural bulkheads but non-watertight in ISO. the...
    Post by: lyqqmxm, Sep 21, 2012 in forum: Boat Design
  6. lyqqmxm
    Thread

    Structural bulkhead in ISO

    Hi all I have some doubts about WT bulkheads and structural bulkheads but non-watertight in ISO. the requirement in ISO 2008 for structural...
    Thread by: lyqqmxm, Sep 19, 2012, 5 replies, in forum: Boat Design
  7. lyqqmxm
    Post

    Problem of maxsurf14 to Rhino4

    Good idea! And wish Rhino invent a new shortcut command for it
    Post by: lyqqmxm, Apr 3, 2009 in forum: Software
  8. lyqqmxm
    Post

    Problem of maxsurf14 to Rhino4

    Thank you! Problem has been solved, but when i split the surface on the chine, each surface will appear multiknots on edge. i use...
    Post by: lyqqmxm, Apr 2, 2009 in forum: Software
  9. lyqqmxm
    Post

    Problem of maxsurf14 to Rhino4

    Thank above! Where is the command of "divide surface on creases"
    Post by: lyqqmxm, Apr 2, 2009 in forum: Software
  10. lyqqmxm
    Post

    Problem of maxsurf14 to Rhino4

    HI: First, i use maxsurf14 academic which including function of exporting to Rhino 3dm file directly. Second, the version only make...
    Post by: lyqqmxm, Apr 1, 2009 in forum: Software
  11. lyqqmxm
    Thread

    Problem of maxsurf14 to Rhino4

    Hello all i'm an user of maxsurf14 academic, but i export my model to Rhino4, i coun't use some command eg. projection, trim and so on. Help!:?:
    Thread by: lyqqmxm, Mar 19, 2009, 10 replies, in forum: Software
  12. lyqqmxm
    Post

    Software rank question

    Thank above
    Post by: lyqqmxm, Jan 7, 2009 in forum: Software