Sp 6 blast. With carbs zinc 11 is a good coating
My company customers were major Oil and marine companies. We fabricated millions of tons of all types of carbons and alloys. I had a...
Ha ha guys thanks for starting my day. Galvanized piece go in an acid bath then go directly in melted zinc. Do you honestly think you need to...
I owed a high pressure certified ASME fabrication plant. What your doing with pre heating, is bring the steel up to temp Your are experiencing is...
I feel 18 ga 2.5" Structural steel channel studs are the answer for the floors Ceiling and floor supports , and the walls . 2 rmax 3/4"...
Thanks thinkg about building a 25' standard pontoon with the same design. I heard diamond plate would break up the water sticking to the bottom of...
The extension cone is 5' long. The transition from 23" Od to 29" od drops 3" in that distance. The flow of the water is also different with cone...
I just installed the cones 23" to 29" od to the rear of the toons. with the extended 3rd , I got up on top with a 135 on this 37' pretty quick....
I am adding a 25" x 24' center pontoon plus in the back there are one 24" dia x 36" pontoons on each side turned the 36" way which can be jacked...
I am adding a 3rd toon A 24' x 25" 3rd toon. Does that solve my problem?:confused:
Weighed Project today , Very surprised with weight. Looks as if TRI TOON needed?
sorry, the boat is 21' x 8' 6". the toons are 21' x 24"dia. This is mainly for salt water flats. The floor I used on the boat I just finish....
I get the message "bad idea" sideways. I am going to build a fishing boat and bond and connect the free Blues together the normal way 21' x 8.5"...