this gets confusing, should i weld in plain mild steel, what about patching things up with corten? < mod note: sorry; posts regarding Brent Swain...
thankx richard, Hempel it will be then :) (i had a choice of hempel, boero, international and sigma)
hi guys, painting a shot blasted hull, should i go for epoxy or 2/1 part polyurethanes? I'm thinking about priming the hull with liquid zinc...
hi guys, Upon inspecting the hull of my recently purchaded steel sailingboat i discovered rust in the usual places, under the toilet area (a...
thank you very much for the info guys
Hi all, On a steel hull replacing the anodes, what's your opinion should you weld the anodes directly on the hull or weld on some threaded rod...
i'll post a few pictures when she's out of the water. I'll take full measurments also. She's hard chine, long keel, ketch rigged.
you've made a very valuable point, thanks ;) i thought lowering the center of gravity she would be a bit stiffer but then again point taken, an...
thanks for the info allan, the concrete has a large crack in the middle, i plan do dril/hammer this out to see how far the crack runs. I'm not...
Hi John, About the drawings you enclosed in post 1, that boat looks like a "Noordsvaarder", seeing the pictures of the boat itself I would...
Hi all, I've purchased a steel ketch which i plan to strip completely and make a new interior, the long keel is filled with scrap iron, steel...