Hey All, I have 2 aq171a with 290sp. I want to change to diesel and have the following question: 1. Can I match an engine to keep my 290sp? What...
Hey i have done a couple of tutorials in rhino and i have got the hang of it. My problems is that most tutorial start from curves while, when i...
Can anyone tell me how to go about designing the superstructure on a hull that has been exported from maxsurf as a rhino3d. are there any...
Hey, I have two 2.5 Tdi ford transit engine in my 19ft boat (planning hull) with shaft and 4 blade props. I cannot make the boat plane it seems...
After designing a hull in Maxsurf can one use rhino to do the structural drawing for fabrication? For what is rhino used after the hull is...
I would like to know if by using seakeeper and hullspeed, model testing could be avoided?? I have never used them no i have no idea of their...
Look at the replacement of teak that was used on MY Bigfish.
Thanks Andrew. I have never used workshop before. So basically once the hull is desgined, workshop can be used to design the hull structure and...
Can the maxsurf package be used during the fabrication phase as in to have the aluminium cutting done and to have the frames designed? Or once the...