Perfect! I attached a few pics. So I am NOT painting it, I will start with bare minimum on the hull. The back of the boat is up against the...
Thanks a ton everyone!!!! I will do all of the things mentioned, I will start basic and minimalist, and see the results. I will add baby steps...
My ultimate goal is the boat is safe to use. That’s my ultimate goal. I don’t care the most about looks.
Those are all great questions! the boat is stored in my garage, with no need to move it. I have 2 space heaters for heat, that is all. I do...
To be perfectly honest, I just want to pick the direction that will promise a good outcome. I don’t want to have to “redo something”, take a step...
I can almost promise this before the test... the bottom half of the hull will likely not cause issues with the cotton ball, while the top half...
Awesome! do you press the cotton ball firmly, with pressure, and then rub it? Or lightly brush it?
I attached the “best” pictures I could take using my phone. If these are not good enough, it is what it is! I really appreciate the help! for the...
I really appreciate the advice everyone! Later today, I will do my best to get better pics of the hull, to see if that helps clarify the...
Mr. Efficiency, I will research that! bajansailor, thanks for the advice!!! I will do just that! I was considering buying a rotary buffer on...
I found one pic on my phone that might give clues to the hull. As you can see (please correct me where wrong) it appears the hull has oxidation on...
The floor board, the top part was rotting out, I removed all of that and got to solid foam, which was hard as a rock, dry, seemed just fine. I...
thanks so much! For starters...When buffering, would you recommend a simple oxidation remover? Or simply use a rotary buffer? I assume I would...
Hey all, I took on a boat project to take up time during the winter months, and I am fully aware I might have tons of work. I have a 1978...