It’s an Asian brand. been out for a while but mainly smaller outboards.
After fairing it will be painted and non skid paint.
Fallguy, thanks for the education. I’ve followed some of your build and comments on the seasled builds. I’ve read that with 1708 it’s best to...
I thought the 1708 was 17oz biax and the 08 =3/4oz mat. my plan was mat down on the first and mat up on the second layer to prevent print...
The rotten core is plywood. Easy enough to remove and replace. The section that slopes from the cabin top to the front deck is not cored. The...
The interior of this boat has fiberglass ceiling liner. So no access to the bottom of the deck unless I cut through the liner and that's not a...
Tops, this is exactly what I plan. But there are other areas with good core. Like the front deck that isn't soft. Core is good i checked but still...
I have a soft spot on my starboard cabin top. The core is gone so I need to replace that. After grinding off all the non skid the deck seems...
Took me a moment to understand what you were saying but I finally understand. That’s not a bad idea. I’ll think it over.
I need help, and Im hoping someone here could give me advice. I want to drill the holes oversized fill with a thickened resin and re-drill for the...
I think that’s the dimensions. Might be just under 22 but close enough.
this was the first hull rendition.. then i came back and fleshed out the blue one bit more. I added the bow flare to attempt to keep it as dry as...
So I got a swift "kick in the a$$" by BlueBell to post what I have. It isn't much but its close to what I wanted. Not sure if she will get built...