Hi Kirsty Coming from a different background I have to agree that foam as you put it is the way to go, but not just any foam. What you want is...
Gentlemen What I have done is bent with a radius 5mm 5083 to 90deg and cut them length wise to form a slight taper. these will be fully seem...
G'Day Gentlemen Just a quick update from back then, after completing the repairs and reading the posts, a bit of soul searching, and a moment of...
G'Day Again Friends I just happened to come across a new push pull gun at the right price and want to use that instead of the old spool gun. The...
Gentlemen Once again thank you for the information. The drawing that TANSL has posted is basically what I have done, except for the new backing...
Gentlemen Thank you for the replies, the 6x12 strips I was figuring that they would act like a brace or a stiffing seam along the hull where the...
Colleagues I have being rebuilding a certain hull for quite a while now, not to get too much into that, but a brief description a 20' planing...
Yep, Good on you Frosty, basically confirmed what i was thinking. Just wasn't quite sure if thay had special rubbers or whatever? I will remove...
Colleagues Still rebuilding this boat of mine but edging closer day by day, I have being searching for tilt cylinder rebuild kits and have found...
Gentlmen Thanks for the replies, and yes you're 100% correct on what you have said. Except the question was asked not to fill holes but to be used...
Boston PM sent to you.
Boston Good to see your getting there with it. The way your doing it is the best way, with a heap of small batches, once you get to know the oil...