I found one way "around" by modifying the rig data manually as if reefing and try and limit heel angles... but it's rather laborious ! I imagined...
Hi all and best wishes for the holidays ! Using MaxSurf VPP is there a way to limit heel angles, say to 20 degrees for instance ? and/or force...
Many thanks for the clarification, it's helpful !
I am sure you are right. I just want to analyse a few things under the hull. If it doesnt make any difference on resistance i 'll stop doing it....
Great, thanks very much ! Re solution #2, how did you get this third extruded surface ? (i am ok then to reshape it and trim) When i use the...
Hi bhnautika and thanks for your reply. I understand most people just develop a basic hull on MaxSurf (MS) and then move to Rhino or other CAD...
Hi there, Any suggestion on how to get a fillet along the intersection line of 2 trimmed surfaces this time, again by using Maxsurf only ? I...
Great, thanks ! Using the tangency while bonding edges looks like a good solution
Thanks but i'd like to know how to do it with Maxsurf alone, just to replicate the model on a.m. videos as an exercise at this stage, and also...
Hello everyone, What is a good way to fillet edges of 2 bonded surfaces with Maxsurf ? I have not found any specific tool to do this. I would...
As a matter of fact (tried to clarify my question in my second post) not looking for symmetry at any heel angle, just looking for tips or hints on...
Believe i understand what you mean, but the issue with such a "cylindrical" shape is the poor hull stability, right ?
On this monohull design (my hull B project, multihulls are another challenge) LCF and LCB do not coincide, but are not so far apart. LCF is some...
