Hello! Thanks for the advice! I usually clean wax surfaces with a product dedicated to removing wax, then sand with 80 grit, blow well with air,...
hello! I would like to apply epoxy over resin over polyester gelcoat. I have seen several instructions on how I should do it. Degrease first, then...
I've been following them for a very long time. But unfortunately they only have videos with carbon or kevlar infusion. I haven't found many videos...
hello! thanks for the reply! I will use a larger nozzle like 2.5mm or 3mm and I will follow up if those spots appear again. I have another...
hello! So far this is what I have used on all the pieces I have laminated 1% concentrated pigment for gelcoats and for ploisteric resins. In my...
Hello! The mold was built with vinylester gelcoat specifically for molds. It was applied in two layers with an interval between layers of 4 hours....
I don't use any thinner! To get good coverage, I make several passes until I get a thickness of 450 microns. This is for the gelcoat of the parts....
I'm spraying with a LVLP gun with 1.8 mm nozzle.I'm using clear spray gelcoat and I'm putting 1% pigment in it.But if I polish the mold with a...
the color is black! I don't feel a different texture, just a change in shade. Those areas seem to be more matte
Can I send you photos on email or other type of comunication?
Hello! It's quite hard to see because of the gloss of the mold. The light is reflected and it's hard for me to take a clear picture. It looks as...
Brand new.Yes I buffed them with a cotton rug.
Hello! After I removed the part from the mold, these marks always remain on the mold but also on the part removed from the mold. The waxing...
