What grit sandpaper should I start with after doing my clear gel layers?
Appreciate all the info, so lower the air pressure okay I have a 2.5mm tip and needle. I’ll try lowering the air pressure and opening up the...
Yessir I mixed 80z of gelcoat and 8oz of duratec and catalyzed with 10cc of catalyst
I did a test on a small portion of the boat with the red base gel with duratec and had orange peel when it cured, must not have been using enough...
Is it true you can’t use primer with gel coat? Like the total boat total protect barrier coat/primer?
I posted a picture above, the picture has like a 1/8” silver stripe outlining black “stripe” I’m going to do a 1/8” in black and the middle part...
So no need to sand the base coat, what about spraying my silver metal flake stripe then the black metal flake out line? Do I need to clear gel...
So definitely let the base coat fully cure, sand the orange peel wipe it down with acetone then mask off for stripes. Would it be better if after...
Okay guys, I have a 1993 nitro 170tf. I have everything I need to spray gelcoat. I have red pigment powder for base color. I have my red metal...
I was reading on your friend Scott’s thread on his boat and it seemed like he didn’t use clear gel until he got everything painted and sanded, is...
Yeah I read on that post from 2019 you said pull the tape shortly after you spray it, I will test and see!
So this is the steps I’m going to take and correct me if I’m wrong, first prime the boat, sand it, spray red base coat, let the base coat cure. (I...
Appreciate it Ondarvr!
Hey guys, I am trying to reach Ondarvr about a few pointers he gave to a guy on this site. The guy mentioned hasnt been active on here since 2019...
