Great information! If that is the case with draft angles Im a bit less hesitant making this a single part mold given the drafts. I don't mind...
by vee do you mean the corner of the seat bottom meeting the seat back?
I am working on a slighter larger console than my previous mini console. Main question is if I am better off making a one piece mold or split......
Wondering if anybody has some thoughts on the varying depths of sing engine cat pods. In the examples below some go all the way to the same depth...
the height
Hey all, I am again designing a new little boat and I am having a hard time nailing down information on outboard bracket size. I know there is a...
There are two 45's running perpendicular. This is supplied from North American Composites and is 1708... had a long in depth conversation with the...
yes the sample on the right is a scrap piece i found laying around but it more or less represents the cloth as a whole.
using poly
Ok so here is the difference between the two... they are both 1708. The sample on the right is what I am used to working with that wets out like a...
Weight is the same... cut some test samples of the same size and they were identical.
Who knows! I will see if that helps at all. Fortunately it was only a 120lb roll so eating the loss is not so bad as a 220lb roll... My supplier...
