Recent content by Ismotorsport

Anyone know the history of these two cats?

The plug will be going up on eBay this weekend with no reserve.

Here are some pics from a performance trimaran build blog... Seems they used a lot of carbon and incorporated the sockets into structural bulkheads. This is from pt-11 tri build. Looks like a strong fast boat.

Phil, Things are very much under construction at the moment. I have the option to choose rudder setup. The transom has opening offset to side but has no swim steps and has a fairly vertical transom face.(only slightly raked). There is also seating aft for the helmsman as well as a winch...

Note : Tiller Steering Time to make some decisions regarding the rudders soon and reviewing the comments still seems undecided. Perhaps a renewal of comment will drum up some ideas... I like the semi balanced transom hung idea, albeit the question remains whether to make it removable or...

I have a Male plug for 52 ft performance bridge deck sailing catamaran available for sale or lease. It is transportable via flatbed truck. Sprayed with gelcoat and sanded to 800 grit and polished and waxed for use. About two months old and has been used twice with success. Contact...

Charly, I have instructions for the crossbeam tang from engineer but It has not been built yet. as this tang is part of a bulkhead that attaches to hull before the crash bow section I did not need to install it yet. As soon as the second hull is complete I will add the Tangs and the crash bow...

This is render showing structural detail without a few recent changes but give the idea of bulkhead and stringer placement. The other pics show examples of similar stringer builds.

Tunnels, Took us about a full month (with weekends off) from pva to 80% fairing work you see in photos. We will surely try and do better than that for next hull but there are always surprises as you know... Trying to keep things moving along. Will be adding a member to team to focus on starting...

Successful Release Thanks for advice Tunnels and MM. Another satisfied customer of Tunnels pva advice..... Some photos from crane day last week. Now we have to do it all over again :)

Almost there... Tunnels and Mike thanks for the words of wisdom. We pva sprayed the entire plug today, which was tricky over the wax but following your advice I got a nice coat. As for plan for pulling, will be using the posts around plug with cam a longs and an A frame for initial pop,( I...

Water/ air inlet construction How does one construct water/ air inlet points on the hull? Where are the best locations to mount these inlets? This image shows how far down the laminates go on the other side of plug. Just up until the wing deck joint.

Note: because this is catamaran hull and there is wing deck attachment the laminates will only go down one side halfway where the wing deck will later join. Only one side will have laminates going all the way to shear line you see in photos. Will this help facilitate release from plug somewhat?