Thanks Michael anf Gonzo for your replies. I attach some pics of the seal, the ball bearing and the thrust bearing. We are going to change...
Hello, I have to align the propeller shafts on this boat. It is a little bit more complicated than usual as each shaft has four supporting...
Hi, I hope you are all doing well. I'm writing to ask your opinion about the posibility of installing new rudders on this boat. The boat in...
Hello guys, Do you know how do they do to trim a big wooden mast from this kind of boat? It is something I've always been ínterested in. How do...
Hello, I finally changed the shape a little bit more. This is the final prototype, I hope you like it and I look forward for some coments. The...
Thanks Gonzo and Messabout for your coments. I have flattened the lower sections and the buttock lines aft. I have attached two options, one...
Hi! it took me a while but I think I've got it, 14 degrees at the transom. What do you think about the bow, is it too high? I just want to keep...
Thanks Gonzo, that is a good point. Actually, there is no transom yet, that is my next step to learn. By the way, I want to extend the deck about...
Thanks Lohring, it is very interesting. While I've been calculatine some loads related to the parachute pull force, I've been playing a bit with...
This is the start of my new proyect in another thread http://www.boatdesign.net/forums/boat-design/parasailing-48962.html#post665061
[IMG] Do you think it is necessary to reinforce the longitudinal frames from the boat? In the worse case scenario there would be a winch...
Does anybody know if there is any standar about safety factor in boat structures?