Recent content by Hiro Chen

  1. H

    Aluminum boats

    It seems you are not active in the forum
  2. H

    Aluminum boats

    Hi, I'm very interested in your designs. My company needs a cooperative designer who with considerable experience in designing aluminum boats. if you are interested, please let me know.
  3. H

    One question of outboard engine

    in case of these, I set a separate well to install outboard, but half of the well height is under the water line. It is madding me ./
  4. H

    One question of outboard engine

    yes , that's why so called "outboard engine"
  5. H

    One question of outboard engine

    it is same with me, i hate abnormal designs. I do not think somebody buyer will like these.
  6. H

    One question of outboard engine

    Yeah, my catamaran is category A. its transom is at a sharp angle to water plane,so that it is difficult to set outboard engines normally. My boss told me we can install outboards front of transom with a likely "moonpool" structure. water sealing becomes a big problem.
  7. H

    One question of outboard engine

    Hi, thanks for your reply, I think it is much easier for monohulls of design category C &D . I got one 40ft sailing catamaran, and primarily used Volvo D1-30 with sail drive as inboard engine. However it could not meet requirements for exhaust emissions standards in my country. If you have any...
  8. H

    One question of outboard engine

    many thanks, design like this is totally new for me. it is grand help
  9. H

    One question of outboard engine

    Thank you for you reply. one more question follows, will CE or other class certification allow this design?
  10. H

    One question of outboard engine

    Thank you for you reply. one more question follows, will CE or other class certification allow this design?
  11. H

    One question of outboard engine

    Had anybody known there was a ship or boat that applied outboard engine at inboard side, which means it applied outboard engine at front of stern or transom like a POD or inboard engine. I'm very sorry for this ridiculous idea, but my boss insisted on this. I have not found any document to...
  12. H

    Nouveau Trimaran Wapa 35 R3

    My opinion,perhaps the caneobodies should be a little shorter than main hull body. The top view looks like a pentagonal profile. The connectors will be under a lower stress
  13. H

    An HDPE Boat Design with a full showcase of the design in the link

    what a pity ,HDPE composites can hardly be repaired like initial performance. Evenly CF has not make it into the mainstream. Forget about it
Back
Top