OK. I am planning to make a 3" ledge of 1/2" pre-glassed divinycell foam strips. How much 3/4 mat should I use on the bottom side? Is this...
I gutted the last 9 feet of my 28 foot fishing boat in order to repower to a single Cummins diesel 6BT 210HP v-drive. Questions about install the...
Doing some repairs, I sprayed my hull with polyester gelcoat with surfacing agent. Afterwards, I found some minor fiberglass defects that I need...
Thanks. I was advised by a respected boat builder that has experience with tunnels to "sharpen the lines" so the water releases, just like you...
gon2sea, Please check out my boat build thread at http://www.bdoutdoors.com/forums/threads/28-foot-force-project.408292/page-12 Wondering any...
A little further along. Tunnel thickness is now 4 layers: 1.5oz mat 1.5oz mat 18oz roving 1.5oz mat I also put an extra layer of mat and...
I am installing a 3" fiberglass stern tube and 1.75" prop shaft in a 27 foot boat. I plan to put the shaft where it needs to go and make some...
Wish I could tell you for sure and I doubt you will get any definite answers on here. I would say you will be OK as long as you beef up the...
Will boxing everything in aft with plywood and adding transverse support be enough? I can even sandwich in a new bulk head over the existing...
I thought of one more option. I think it is the best one so far with what I have going on already: [IMG] I am going to buy another 20' microlam...
The boat is pretty much all made with 1/2" plywood that runs from the hull to the deck. When I installed the stringers, I basically tabbed the...
Boat Specs: LOA: 27 feet LWL: 24 feet Beam: 9 feet Weight: 7-8000ish lbs Hull Type: Deep-V / Planing Engine: Cummins 6BT 210HP Gear:...