Looking to remove very old through hull fittings below the water line. I want to remove and glass over them. To me it seems pretty strait forward...
I haven't bought steps yet, I'm thinking stainless or maybe aluminum, leaning to stainless. I don't know the wall thickness of the mast and I...
Mast is aluminum, oval not sure the thickness.
I want to put some mast steps on my sail boat , any advice? Fasteners, should I calk where the step connects with something?
Interesting thoughts on the rudder, it is pretty old and the rudder has held all this time. Would like to install a skeg at some point though. My...
My boat does not have a full keel and the rudder just hangs in the water . I'm wondering about building a skeg in front of the rudder to give it...
That's what I was thinking about but after reading about the reason the motor is mounted there I'm thinking of something different. I'm thinking...
My concern was that it will increase weight at the stern of the boat if I move it back there. Still the bulked they have installed that forms the...
My 27 foot fiber glass sail boat has an outboard engine but it's mounted behind the transom. It basically has two transoms an interior one and an...
Not sure really it's a lot of material and it's thick. I suppose it could be wadded up into a lot of shapes kind of like putty and compressed to...
I don't really have a goal just curious about it. It's plentiful , can often be found for free in trash piles and it is fiberglass. I suppose you...
