ok..it is a specific skin layer ve resin.... was going to do 4x 1150 then core then 4x 1150 for the bottom side and rear end of the hull then 4...
? anyone have any ideas
have a finished mould for a 5.4 mtr hull have been doing test panels and cant seem to get rid of the print thru of the soric core material...
yes getting a barcol tester in at the start of the week...after the post cure is done...turned the mould upside down and put a plastiv drop sheet...
thanks mate i took the pics...hmmm doesnt seem so bad now...phew haha yes it was tooling gelcoat..the tg? i have no idea?...but im going to find...
heres a couple of pics of the problem it seems its flat in sanded mode but soon as you hit it with the buffer things appear...:confused: you can...
Yea I'll get on to it this afternoon ;)
To the touch it's hardly noticable but if you go over the suface with 2000 grit wet rubing you can see th tops coming off the orange peel ... So...
No thinners was added the correct amount of catalist was added as well and the dwell time between coats was sugested by our fiberglass/ gelcoat...
hi guys have recently finished a mould for a 5.4 mtr boat everything seemed to go well until....:confused: tooling gel coat problem...was...