McCaffrey, This set up will be quite an undertaking. Just so we're on the same page, I want you to know that I know little to nothing about...
McCaffrey, First, looking at Kaluvic's reply, it appears that he has the engine coupled to a gearbox that is driving the prop shaft. You are...
Mccaffrey, I don't know much about hydraulic propulsion for boats, but I do know a lot about hydraulics, and hydraulic excavators. Here are a...
Frosty; Can't trim it. OMC 400 stringer. I can change the trim angle by adjusting the front engine mount. I am wondering if maybe the float...
Frosty: when running wide open at 3400 rpm, i can back off to about 2/3 throttle before the rpm's start to come down. If I move the throttle back...
Frosty, I have confirmed full throttle with the linkage. Its funny you say that though. I work on CAT equipment, and don't know how many times a...
OK fellas, Here is an update, but first let me summarize everything up to this point. Boat: 16.5 foot Seaswirl open bow. "whale tail" and trim...
Plugs are about as white as they can get...now what?
Par, maybe I misspoke. As I said before, I don't have much experience with gas engines. The distributer cap, the points have been removed and...
I had another thought. The distributer has been replaced (not by me), and has been updated with an electronic ignition conversion kit. Is there...
Gonzo, Should I check them now, or should I check them right after a full speed run? If I check them now on the trailer, the last load the...
Hey all, I have a 1986 seaswirl open bow 16.5' 120 omc (2.3l gm engine w/ 2 jet Rochester). I picked this boat up earlier this year, and have...
Scratch that! The guy that was going to sell it flaked out. Why is it that the typical person's word is not worth a sh#* anymore?
I have the opportunity to purchase this boat. It is powered by a 4.3 v6, with a volvo duoprop. Would like to know the quality of construction of...