Recent Content by GBennett

  1. GBennett
    Post

    Below water fibrglass repair

    Thanks, So my basic plan will be to do the interior part of the repair. At the same time I will make and tab in the stringers and transom. I plan...
    Post by: GBennett, May 7, 2015 in forum: Fiberglass and Composite Boat Building
  2. GBennett
    Post

    Below water fibrglass repair

    Thanks Mr Efficiency and PAR. You make it sound easy enough. I have read that surfaces exposed to the water require Epoxy but that Epoxy doesn't...
    Post by: GBennett, May 7, 2015 in forum: Fiberglass and Composite Boat Building
  3. GBennett
    Post

    Below water fibrglass repair

    I haven't been able to get a good picture from the inside. The cut is on a flat section just after the hull comes up. Right next to it is where...
    Post by: GBennett, May 7, 2015 in forum: Fiberglass and Composite Boat Building
  4. GBennett
    Post

    Below water fibrglass repair

    [ATTACH] It is on the bottom near the rear, in the one the cut is not visible but the arrow shows where it is so you can get a better idea. The...
    Post by: GBennett, May 7, 2015 in forum: Fiberglass and Composite Boat Building
  5. GBennett
    Thread

    Below water fibrglass repair

    [ATTACH]Not sure this is the right place to put this question. I was given a fiberglass 1983 StarCraft. In the process of removing the rotted...
    Thread by: GBennett, May 7, 2015, 9 replies, in forum: Fiberglass and Composite Boat Building