Thanks for the advice TANSL. At the moment I'm concentrated on patching the transom hole.I'll be using the payson technique as suggested by...
Thanks PAR. That's what I think I'll do then. What do you think about the strength of the joint after cutting through it for the new transom shield?
Hey PAR! Do you think it'll be OK when I cut through the new hole? If the plug was to stay whole then I can imagine it retaining its strength...
Transom repair with suggested payson technique. OK, so in the drawing you'll notice that the exciting cutout is very close to the hull and it...
I've made a plan for the payson repair that SamSam suggested with the help of PAR's fantastic webpage. i hope the drawing makes sense.
We've just had cyclone NIna rip the west coast of Norway a new one....! Its been a stressful night, to say the least... My boat is still on its'...
Hi Par. OK, I can see this being a far superior solution as compared to the tongue and groove approach. Also I was a bit concerned as to how I'd...
Thank you for the advice Perciles. I'm thinking about a tongue and groove solution. I'll be posting a drawing of the concept soon for comment.
Hi PAR. That's definelty another option I've been thinking about,however I've been worried about whether the transom will retain its strength in...
Thanks for the advice Par. I've had a good look at the stringers and they're in good condition (engine mount holes have not had water sitting in...
Hey Guys. I'm new to the forum, but I've been reading you great advice for a long time! I'm planning on starting my transom modification, from...