photos and price. goodfolksfinancial@gmail.com
Please send pix of boat and molds. goodfolksfinancial@gmail.com
I am surfacing a plug and I have a lot of duratec sanding primer left. I wonder If I can use this with the high gloss additive for the finish...
Planning on wet storing aluminum hull in Florida.( High speed Cat) that is frequently trailered.Hull (including wet surfaces are awlgripped)...
Im not sure what you are trying to accomplish.Does the original set up have an outboard well inside of a cut down transom?I.e. typical old style...
I'm trying to troubleshoot an electrical problem - aluminum hull, twin honda outboards, two batteries.Boat is out of water on trailer. Port...
Have isolated problem to the honda outboards.The negative ground to the engines completes the circuit thru the hull,any thoughts?There may be a...
Have an electrical leak(DC 12 v.) in an aluminum hulled boat. I am trying to troubleshoot. Should there be any continuity between the negative...
An epoxy barrier coat such as interprotect by interlux followed with bottom paint is the usual way to go. Why bother with gelcoat?
Make sure the existing glass is cleaned of contaminants,then key it with 80 grit or coarser. Epoxy will stick to existing polyester very well.New...
Thanks,Eric.This seems consistent with my prototype's performance.