Ok thanks for the info guys. I shall make sure i beef up the keel a bit more. Is 2inch keel and 1.5 chines ok??
I ment that ill change to a lighter glass to make corners easier.
Nah im not leaving out the csm. id do the stringers first then the knees/bulkheads. The hulls only 14foot and i was going to put one layer of csm...
Sorry for the late replies guys. But ive decided to just stick to the 400g biax and chop ive been using. Will save me the hassle of the corners.
What was there before was 6 2 x 6 inch thick solid timber stringers (way to much) I would like to change these to ply wood about 1.5 x 4 inch...
Ok guys sorry for the late reply. I was going to use it coz it was alot cheaper then what im using atm 400g. I believed i would also save on resin...
A rebuild of transom/stringers/and a layer through the whole hull. Its got a layer of 300g chop stiched to it. Its going over cured polyester...
Hi ive picked up 50m of 300/1200g biaxial cloth for a steal. 45$ Just wondering if this will be safe to use on a boat with polyester resin?...
So transoms out and rear skin is delaminated. So ive started grinding the delaminated skin out and the hull for bonding when i tab in the transom...
Sorry about large pics im going to have to start scaling them down on my phone. Anyway what i have planed is to build up the transom 5 inches...
Ok so now ive started to get to work after a while of planing. So the last couple of days ive started to gut the interior and remove all...
Update. So ive finally come up with a practical way to design the interior and add some flotation. So here it is tell me what you think [IMG]
My 50hp motor weighs 110lb i have cruised around with 4 people squished in the boat and the boat had no problem supporting the weight. It may be a...
4Fx. That boat looks sick do u have a pic of the planing surface? After im done with these boats. Cougar cub/stiletto. I will have a shot at...
