I have a unique downeast style 28' Albin prototype built for a 1994 Miami boat show. Originally came with a Volvo Penta 218 Hp Diesel engine with...
Thank you for all your help, today I bought 2 30" shaft engines, so I will put back to the original position
I'm not too worry about drain holes, I can relocate them to the inside bottom of the pontoons close to the keel like on many inboards and ski...
I don't know that, I never drive this boat, when I got it motors was already removed. When I removed bottom paint I noticed it was trim tabs on...
[ATTACH][ATTACH]
That is the picture when I got the boat, after I removed both brackets sandblasted and powder coated again. This is the time to put them back, so...
[ATTACH]
The aluminum brackets for 30" motors 5" above the keel, so if I lower the bracket with 5" the cav plate will be the same position. I have a Prokat...
I got the boat without motors, so I can buy 25 or 30" motors. This is planning hull, very shallow 20" draft so I don't think I will have problem...
I have a 33' power planing catamaran hull, came with two aluminum Armstrong outboard brackets from the factory for 30" outboard motors, bottom of...
This is a planning hull, so has relatively wide pontoons, draft only 20", I never drive the boat yet, but there is the video on youtube from the...
I have a Prokat 3200 power catamaran with pair factory Armstrong brackets. The factory setup was for 30" outboard engines, so the bottom of the...