I am still messing around with getting my pocket tunnel to perform on my 20' flatback proline (1975 model). I have upgraded to a 4 blade trophy...
It is a 20" shaft. DF140TLK3 Kevin The second last digit in the model designation refers to the boat transom height that the engine is...
Like this? I can run the jack plate up 7" and the only item below the transom is a bit of the skeg. [IMG]
The pic I posted is before I changed to a 4 blade trophy plus prop. The prop changed helped some but performance still is sketchy. Trim and jack...
I recall that the cavitation plate should be level with the keel. Since I have a setback I would think it could be a bit higher. Any thoughts...
I have a custom pocket tunnel that was added by a previous owner on my 20' center console. I would like to close it in as I think it is hurting...
I probably could get another 6 inches in length to the tunnel with a longer trim ring. Will this still allow me to jack plate up as high. I know...
She gets up on plane really well in deep water. I am going to find a local dealer who will let me demo some props. I was running on Saturday...
Here are the measurements on the tunnel. Lenght: 41" Width at transom: 20.5" Height at transom: 8" Trim ring addtional lenght: 4" I...
Village & Pericles, Thanks for your responses. The boat has been running great all week as I have now have a command over where the trim and...
anybody Just looking for thoughts and ideas on how to tweak this design. I have a full week on the water starting tomorrow. kls
I picked up this 1975 20' proline flatback that was re-worked in 2003. The rebuilder installed a pocket tunnel. I have only run it a few times...