Recent Content by fish is a fish

  1. fish is a fish
    Post

    Panga Transom Question

    Their is a guy in San Diego selling the exact same 18' for 2000$ (new) I was just not sure about the transom either.Also it says it is rated up to...
    Post by: fish is a fish, Dec 31, 2006 in forum: Powerboats
  2. fish is a fish
    Post

    monkeyads.com

    Boat source, Being a broker you should not be using craigslist boat section.... thats a joke... I am on San Diego c/l all the time and I see all...
    Post by: fish is a fish, Nov 14, 2006 in forum: Marketplace
  3. fish is a fish
    Post

    Grumman 5.0 repaint

    soda it is! will Post some pics of B/A later.;)
    Post by: fish is a fish, Nov 11, 2006 in forum: Powerboats
  4. fish is a fish
    Post

    engine shaft length

    I know this thread is old, but I found this site http://www.smalloutboards.com/shaft.htm to be helpful when I had the same question.
    Post by: fish is a fish, Nov 8, 2006 in forum: Outboards
  5. fish is a fish
    Post

    The power yacht at the end of The Island ?

    The fuel capacity is 5,812 gallons. Fuel consumption at top cruising speed is one liter per second, or about 15 gallons per minute! no thanks...
    Post by: fish is a fish, Nov 7, 2006 in forum: Powerboats
  6. fish is a fish
    Post

    Grumman 5.0 repaint

    I would prefer NOT to strip the whole boat, but rather get proper adhesion with a buffing/sanding primer of some sort on the original factory...
    Post by: fish is a fish, Nov 7, 2006 in forum: Powerboats
  7. fish is a fish
    Post

    Grumman 5.0 repaint

    You are correct it is riveted. So I do need to remove the old paint,I was thinking of some sort of two part buffing primer applied over the old...
    Post by: fish is a fish, Nov 7, 2006 in forum: Powerboats
  8. fish is a fish
    Post

    Grumman 5.0 repaint

    Thanks Jimbo,I will check out Awl-Grip's site.
    Post by: fish is a fish, Nov 6, 2006 in forum: Powerboats
  9. fish is a fish
    Thread

    Grumman 5.0 repaint

    I recently purchased a Grumman 5.0 C.C. got (what I think is) a good deal. The hull is in great shape, other then the original paint is scraped...
    Thread by: fish is a fish, Nov 6, 2006, 7 replies, in forum: Powerboats