Recent Content by elskimo

  1. elskimo
    Post

    Joining a wooden deck to a fibreglass hull

    I am about to do the same. I am replacing old wood deck with new to fiberglass hull. I was instructed to use epoxy resin and 4 in fiberglass tape....
    Post by: elskimo, Jul 15, 2009 in forum: Fiberglass and Composite Boat Building
  2. elskimo
    Post

    scaffolding help

    I am not too familiar with how to do what you are doing but could you turn the boat upside down and walk under it ? If not ... how about a...
    Post by: elskimo, Jul 15, 2009 in forum: Fiberglass and Composite Boat Building
  3. elskimo
    Post

    Cockpit Replacement

    I do not have pics of my boat but this is almost identical to what i am dealing with :
    Post by: elskimo, Jul 10, 2009 in forum: Boat Design
  4. elskimo
    Post

    OK.........take a deep breath (adding sail to houseboat?)

    Give it a shot. The only thing that you may want to consider is all the people looking at you saying wtf. But I think it would be cool.
    Post by: elskimo, Jul 9, 2009 in forum: Boat Design
  5. elskimo
    Post

    Cockpit Replacement

    Thanks for the advise. The reason I say the aft bulkhead is not load bearing is because it is as you described. About 1/2 is glass and the...
    Post by: elskimo, Jul 9, 2009 in forum: Boat Design
  6. elskimo
    Thread

    Cockpit Replacement

    I am about to venture on replacing the rotten cockpit and rear cabin wall of my 40 ft sportfish. Has anyone done this and do you have any pointers...
    Thread by: elskimo, Jul 7, 2009, 9 replies, in forum: Boat Design