We have stopped trading. Machines are packed up and ready to send, the pictures I have are not too great now that I look at them a few months on....
Thanks for that Hi again Thanks for the replies. We got in trouble with local police over emissions! So I've been hiding in UK until things...
samsam sorry for long reply Hi Samsam TY for reply. I came out to UK to assemble the parts I had to deliver, so I have been off forums for a...
Lucky me Lucky me :)
Mechanical & chemical It seems to me from scanning this thread that most people when traditional mould building rely on a mix of Mechanical and...
I tried this recently and it worked well. Sealer, semi-perm release. 2 coats of say Mirrorglaze or Oscars mould release wax. Normal waxing...
Good idea as regards over laying the back I think the idea of more heavily laying the back of the laminate sounds a good idea. I'll try this. Its...
Inner & Outer Yes, slightly I think the inner layer has more. But its fractional. Within a mm I would say. I'll check with a gauge like you...
Thanks SamSam Appreciate the reply. They are already distorted when we pull them. They are large flat panel structures, polyurethane in a...
Hi all I use compressed air to release parts normally. Anybody have an experience of parts being permanently distorted by high compressed air...
Hi I have a number of hard steel moulds that I would like to surface with polyester. I have some high build primers & finishing coats. Anyone...