Well thanks for the reply Too seal the shaft too the housing I mesured the clearances I had inside and the shaft diameter and ordered the seat too...
Here are some pic of my out board about 2.5hp I think. Works great. Some of the parts I used are a head off of a dewalt angle grinder for my...
I was thinking plastic welding the tube through the plastic as for the weight I dont realy care but finding a platic tube with the same chemical...
Thats what I was thinking But my hull is pastic but I can work with that. What are G Clamps?
Thanks forthe info but I'm looking for a DIY Job I will Try it one of these days. TIME IS THE FACTOR.
Thanks I'll check it out.
Thanks.
I ment on board. Not too hard I dont Think? And would work great with a simular steering system too a jet ski. Rather than a rudder.
Anyone here ever mount a electric trolling motor in a kayak I mean on board?
Hi I'm New here but I played with home made outboards a few times. This out board works great and I will post some pic soon as I get a chance I...